Customizing the Browser Tab Label

You can customize the label that appears on the tab of the Web browser that you use to open the device's Web interface. By default, the tab displays "AudioCodes". You can change this to display either the IP address of the device or any customized text.

● You can customize the tab to display the device's IP address. This is applicable only if a logo image is used in the Web interface (see Replacing the Corporate Logo with an Image).
● If you are using the default AudioCodes corporate logo image in the Web interface, you can only customize the tab to display "AudioCodes" or the IP address.
● You can customize the tab to display text other than "AudioCodes", only if you are using a non-AudioCodes logo image in the Web interface.
● If you have replaced the corporate logo image with text (see Replacing Corporate Logo with Text), the same text is used for the tab.
➢ To replace the browser tab label with the device's IP address:
1. Create an ini file that includes the following parameter settings: 
UseWebLogo = 1
WebLogoText =

If you have never configured the [WebLogoText] parameter, you can omit it from the ini file. If you have configured it before, then set it to an empty value, as shown above.

2. Load the ini file using the Auxiliary Files page (see Loading Auxiliary Files).
3. Reset the device with a save-to-flash for your settings to take effect.
➢ To customize the text of the browser tab label:
1. Create an ini file that includes the following parameter settings:
● To replace the default text: 
UseWebLogo = 1
WebLogoText = <your text, for example, Hello>
● To restore the default text ("AudioCodes"): 
UseWebLogo = 0
2. Load the ini file using the Auxiliary Files page (see Loading Auxiliary Files).
3. Reset the device with a save-to-flash for your settings to take effect.